Warnings And Safety; For Your Safety - Delta ELEKTRA UV E Serie Notice De Montage Et D'entretien

B. WARNINGS AND SAFETY
Elektra UV reactors are ready to install, no work is required inside the reactor.

FOR YOUR SAFETY:

This product should be installed by a professional service technician or
similar person, qualified in electrical equipment installation.
Improper installation and/or operation could cause serious injury, property
damage or death. Improper installation and/or operation will void the
limited warranty.
READ ALL THE INSTRUCTIONS IN THIS MANUAL BEFORE
SWITCHING ON THE ELEKTRA UV APPLIANCE.
The reactor must be installed in a technical room, protected from light and rain.
The reactor must be installed in a dry zone.
The installation zone temperature must be within 0°C and 40°C.
Ambient humidity must be < 80%.
Keep any sources of hydrochloric acid vapours away from the installation.
Make sure you choose a position where the lamp can be taken out – the
AVAILABLE HEIGHT should be DOUBLE the total height of the appliance.
7 CAUTION:
We recommend the presence of a by-pass.
7 Before accessing the connection terminals, ensure that all
supply circuits are disconnected.
7 The reactor installation as a whole must be protected with a
suitably adapted circuit breaker.
(See A. Technical characteristics)
7 Check that cable complies with legislation and the required power
level. (See A. Technical characteristics)
V5 Elektra E et ES Anglais.doc
Marque, Modèles et Brevets déposés - Produits exclusifs
INSTALLATION
RECOMMANDATIONS
Copyright DELTA UV
Page 4