Télécharger Imprimer la page

BEGA 84 563 Fiche D'utilisation page 2

Publicité

Sicherheit
Für die Installation und für den Betrieb
dieser Leuchte sind die nationalen
Sicherheitsvorschriften zu beachten.
Die Montage und Inbetriebnahme darf nur
durch eine Elektrofachkraft erfolgen.
Der Hersteller übernimmt keine Haftung für
Schäden, die durch unsachgemäßen Einsatz
oder Montage entstehen.
Werden nachträglich Änderungen an der
Leuchte vorgenommen, so gilt derjenige als
Hersteller, der diese Änderungen vornimmt.
Produktbeschreibung
Leuchte besteht aus Aluminium,
Aluminiumguss und Edelstahl
Beschichtungstechnologie BEGA Unidure
Sicherheitsglas weiß
Befestigung des Lichtbauelements
mit dem Erdstück 71 192 oder mit dem
Befestigungssockel 71 191 zum Aufschrauben
auf ein Fundament (siehe Ergänzungsteile)
Anschlussdose mit
2 Leitungsverschraubungen zur
Durchverdrahtung der Netzanschlussleitung
bis ø 8-17 mm max. 5 × 4@
1 Leitungsverschraubung werkseitig
mit Blindstopfen verschlossen
Mit eingesetzter Tür aus Aluminium
Vierkant-Türverschluss (SW 8 mm)
BEGA Ultimate Driver
®
LED-Netzteil
220-240 V x 0/50-60 Hz
DC 176-264 V
DALI steuerbar
Zwischen Netz- und Steuerleitungen ist eine
Basisisolierung vorhanden
BEGA Thermal Control
®
Temporäre thermische Regulierung der
Leuchtenleistung zum Schutz temperatur-
empfindlicher Bauteile, ohne die Leuchte
abzuschalten
Schutzklasse II 2
Schutzart IP 65
Staubdicht und Schutz gegen Strahlwasser
Schlagfestigkeit IK06
Schutz gegen mechanische
Schläge < 1 Joule
c  – Konformitätszeichen
Windangriffsfläche: 0,44 m²
Gewicht: 24,0 kg
Vor der Montage zu beachten:
Die Befestigung des Lichtbauelements erfolgt
mit dem Erdstück 71 192 oder mit dem
Aufschraubsockel 71 191 auf ein Fundament
(siehe Ergänzungsteile).
Für den elektrischen Anschluss ist eine
Kabellänge von ca. 1 m über Oberkante
Bodenbelag ausreichend. Der Fußpunkt des
Lichtbauelements darf nicht tiefer als die
Oberkante des Bodenbelages liegen.
30 × 100
2 / 4
Safety
The installation and operation of this luminaire
are subject to national safety regulations.
Installation and commissioning may only be
carried out by a qualified electrician.
The manufacturer accepts no liability for
damage caused by improper use or installation.
If subsequent modifications are made to
the luminaire, the person responsible for
these modifications shall be considered the
manufacturer.
Product description
Luminaire made of aluminium, aluminium alloy
and stainless steel
BEGA Unidure
®
®
Safety glass, white
Fixing of the light building element with
anchorage unit 71 192 or mounting base
71 191 for bolting onto a foundation
(see accessories)
Connecting box with
2 cable entries for through-wiring
of the mains supply cable
up to ø 8-17 mm max. 5 × 4@
1 screw cable gland
factory-closed with sealing plug
With inserted door made of aluminium
Square door latch (wrench size 8 mm)
BEGA Ultimate Driver
LED power supply unit
220-240 V x 0/50-60 Hz
DC 176-264 V
DALI controllable
A basic isolation exists between power cable
and control line
BEGA Thermal Control
Temporary thermal regulation to protect
temperature-sensitive components without
switching off the luminaire
Safety class II 2
Protection class IP 65
Dust-tight and protection against water jets
Impact strength IK06
Protection against mechanical
impacts < 1 joule
c  – Conformity mark
Wind catching area: 0.44 m²
Weight: 24.0 kg
Notice prior to installation:
The fixing of the light building element can be
done with anchorage unit 71 192 or screw-on
base 71 191 for bolting onto a foundation
(see accessories).
A cable length of approx. 1 m above top edge
of the mounting surface is sufficient for the
electrical connection. The base of the light
building element must not be below top edge
of the mounting surface.
100
100
3 3
80
80
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info @ bega.com · www.bega.com
coating technology
®
®
500 × 500
Sécurité
Pour l'installation et l'utilisation de ce luminaire,
respecter les normes de sécurité nationales.
L'installation et la mise en service ne doivent
être effectuées que par un électricien agréé.
Le fabricant décline toute responsabilité pour
tout dommage résultant d'une mise en œuvre
ou d'une installation inappropriée du produit.
Si des modifications sont apportées
ultérieurement au luminaire, l'intervenant sera
considéré comme étant le fabricant.
Description du produit
Luminaire fabriqué en aluminium, fonderie d'alu
et acier inoxydable
Technologie de revêtement BEGA Unidure
Verre de sécurité blanc
La fixation du profilé lumineux est effectuée au
choix sur pièce enterrée 71 192 ou socle de
fixation 71 191 à fixer par vis sur un massif de
fondation (voir accessoires)
Boîtier de raccordement avec
2 presse-étoupes pour branchement en
dérivation d'un câble de raccordement
jusqu'à ø 8-17 mm max. 5 × 4@
1 presse-étoupe équipé en usine de
bouchons d'étanchéité amovibles
Avec porte fabriquée en aluminium
Fermeture à vis à quatre pans (taille de
clé 8 mm)
BEGA Ultimate Driver
®
Bloc d'alimentation LED
220-240 V x 0/50-60 Hz
DC 176-264 V
Pilotage DALI
Une isolation d'origine existe entre le réseau et
les câbles de commande
BEGA Thermal Control
®
Régulation thermique temporaire de la
puissance des luminaires pour protéger les
composants sensibles à la température, sans
pour autant éteindre les luminaires
Classe de protection II 2
Degré de protection IP 65
Etanche à la poussière et protégé contre les
jets d'eau
Résistance aux chocs mécaniques IK06
Protection contre les chocs
mécaniques < 1 joule
c  – Sigle de conformité
Prise au vent : 0,44 m²
Poids: 24,0 kg
À respecter avant l'installation :
La fixation du profilé lumineux est effectuée
au choix sur pièce enterrée 71 192 ou socle à
visser 71 191 à fixer par vis sur un massif de
fondation (voir accessoires).
Pour le raccordement électrique une longueur
de câble d'environ 1 m au-dessus de la couche
de finition du sol est nécessaire. Le bas du
profilé lumineux ne doit pas se trouver en
dessous de la couche de finition du sol.
befestigte Oberfläche
Paved surface
Surface consolidée
verdichteter Boden
Compacted soil
Sol damé
Erdreich · Soil · Terre
Beton · Concrete · Béton
Sauberkeitsschicht
Sub-base
Couche d'assainissement
Drainage
®

Publicité

loading

Ce manuel est également adapté pour:

B 84 563ak3B 84 563ak4B 84 563k3B 84 563k4