Télécharger Imprimer la page

Honeywell QUIETCLEAN HFD230 Serie Guide D'utilisation page 3

Publicité

Les langues disponibles

Les langues disponibles

ELECTRONIC FILTER CLEAN REMINDER
This model air purifier has an electronic filter check to remind you when to
check and clean the washable ifD
filter and washable pre-filter based on the air
®
purifier's hours of use.
When the filters need to be cleaned, the CHECK FILTERS light will remain on until it
is RESET. You may unplug the air cleaner without interrupting the filter check.
A red LED light** will illuminate when it is time to clean the filters.
You should periodically check the filters. Depending on operating conditions, the
filters should be cleaned at least every 3 months.
To RESET the Electronic Filter Check:
After the ifD
filters and pre-filter have been cleaned and returned to the unit, with the unit still in POWER
®
OFF mode, press and hold the CHECK FILTERS button (see Fig. 5) for 3 seconds. The CHECK FILTERS red
LED will flash twice indicating the filter check has been reset. The red LED will no longer be illuminated.
These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent
upon the concentration of contaminates going through the system. High concentrations of contaminates
such as dust, pet dander and smoking will reduce the useful performance of the filter.
REMOVING THE FILTERS
The ifD
®
filters are supplied within the air purifier.
• Turn-off and unplug the air purifier. While pressing on the release tab at the
top of the rear grille, pull the grille towards you and remove it (See Fig. 6).
Gently push along the edge of the filter frame and pull forward. Repeat for the
second filter.
• After cleaning, place filters back into the air purifier housing and snap filter grille
back into place.
CLEANING THE IFD
®
FILTERS
To clean the ifD
filters:
®
• After removing the ifD
Filters from the air purifier, follow the steps below to
®
wash the ifD
filters.
®
Turn the power off and unplug the air purifier.
• Rinse the filter with clean tap water (Fig. 7)
• If the filter still appears dirty, proceed to "Washing,"
otherwise proceed to "Drying."
Washing:
• Remove the ifD
filters from the unit.
®
• Fill a sink with lukewarm water and add a few drops of mild dish soap.
• Gently swish the filters in the soap solution to clean.
• Soak the filters for 2-3 minutes. Do not leave for an extended period of time.
• Rinse the filters with clean tap water (Fig. 7).
4
HFD230B_OM_31IMH230190_r2_17NOV14.indd 4-5
CLEANING THE IFD
®
FILTERS (Cont)
Drying:
Fig. 5
• Shake the filters to remove any excess water.
• Place the filters with the honeycomb side down on a plush towel.
• Note that the filters may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the ifD
®
filters to dry for a few hours or overnight.
• When the ifD
®
filters are completely dry, place back into the air purifier.
CAUTION:
• Never place wet ifD
®
filters in your air purifier.
• The ifD
filters is NOT dishwasher safe. Do not place the ifD
®
to other extreme hot water conditions.
• Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD
MAINTAINING YOUR WASHABLE PRE-FILTER
The pre-filter helps pick up large airborne particles that
enter the rear grille. This pre-filter can be periodically
removed and shaken to clean it. Alternatively, it can be
rinsed by hand under warm water (Fig. 8). Let the
Fig. 6
pre-filter air dry completely before inserting back into
the grille (Fig. 9). If you need to replace this item, please
call 1-800-477-0457 or visit www.kaz.com.
OPTIONAL: Changing the Odor Absorbing Pre-Filter
If you have chosen to use the odor absorbing
effectiveness for odor adsorption over time and will need to be replaced.
To insert it into the unit, simply place securely into the rear grille in lieu
of standard pre-filter as shown in Fig. 9.
If using the odor absorbing
pre-filter, it is recommended that you store the
K
Fig.7
original washable pre-filter in the event that you decide to use it in the future.
NOTE: The odor absorbing pre-filter is not washable.
CLEANING AND STORAGE
We recommend that you clean the air purifier at least every 3 months and before extended storage. Use
only a dry cloth to wipe the external surfaces of the air purifier. DO NOT USE WATER, WAX POLISH, OR
ANY CHEMICAL SOLUTION.
filters in a dishwasher or subject them
®
filters.
®
Fig. 8
Fig.9
pre-filter it will lose its
K
Washable
Rear
Pre-filter
Grille
5
11/17/14 6:10 PM

Publicité

loading

Ce manuel est également adapté pour:

Quietclean hfd230bv1