Cleaning & Maintenance; Troubleshooting - Inventum MV010B Mode D'emploi

6
cleaning & maintenance
Frost can settle on the rear wall of the cooling compartment. It is removed automatically.
Before cleaning the appliance set the thermostat to OFF and always unplug the appliance.
Remove the food. Clean the interior of the appliance. Simply remove the shelves, drawers and door compartments to clean
them by hand. Do not clean the interior accessories in the dishwasher. Use warm water and a neutral detergent, such as
baking soda, to prevent any bad smells occurring. Use two tablespoons and a quart liter of warm water. After cleaning, rinse
the interior with clean water and leave the door open to let it air dry for 1 to 2 hours before the power is turned on. Be careful
not to affect the electrical insulation properties when rinsing with water.
For areas that are difficult to clean in the refrigerator, such as narrow gaps or corners, it is recommended to wipe them
regularly with a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure
no contamination can accumulate in these areas.
Clean the outside of the larder and the door gasket with mild soap and water. Use a soft moist cloth.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order
to maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage
the fridge surface and interior. Boiling water and benzene may deform or damage plastic parts.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is blown, it must be
replaced by a qualified person to avoid any hazard. Contact the Inventum service department.
7

troubleshooting

Problem
Appliance is not functioning;
light does not work
Temperature inside the
larder is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
22
• English
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or
vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards