EAS ELECTRIC EPUR660 Manuel D'instructions page 24

Cleaning of the filter components
1
When the last bar of the
progress bar turns red and the
cleaning indicator light is on, it
prompts that the Pre-Filter
needs to be cleaned
Pre-Filter
Clean
5
Dry the Pre-Filter
2
Unplug the power cord, and
take out the Pre-Filter
6
Assemble the Pre-Filter
3
Vacuum up dust with a vacuum
cleaner or wipe it with a cloth
7
Plug the power cord, and
start up
8
4
If there is a lot of dirt, the common
diluted kitchen detergent is used to
soak, and then clean it
Soaking time
is about
10min
8
Long press the PM2.5 detection
button for 3s, the cleaning indictor
light is off, and the Pre-Filter is
restored.
PM2.5
(Press 3s, to
reset Filter)
Long press for 3s
V.2