TCL 20D1 Mode D'emploi page 5

1a.
Step 3:
Install the Casters Wheels
Tilt the unit no more than 45°and forcibly insert the casters. Make sure the plate of the castors
is flush against the bottom of the unit. If the appliance has pre-installed casters, this step can
be skipped.
How to Control Your Dehumidifier
All the basics you need to know!
When first operating the dehumidifier, run it in Continuous mode for 24 hours.
1.
Press the Power button once to manually turn the unit on. Press the Power button once more
2.
to turn the unit off.
Humidity Selection – Press the "down" or "up" buttons to choose the desired relative
3.
humidity. Once the preferred humidity is selected, the display will show the actual room %
humidity. Each press of the same button will change the desired room humidity by 5%. The
room humidity is selectable from 35% - 80%, or continuous. The until will cycle on and off
to maintain the humidity level chosen on the digital display. If you want the dehumidifier to
operate continuously regardless of the room humidity, press the MODE button until you see
the "CO" on the digital display. This will enable continuous operation and the "Continuous"
indicator will light up on the control panel.
Fan Speed – press the FAN SPEED button to cycle through the different fan speeds (High,
4.
Low). The fan speed can be visually distinguished by the fan speed indicators on the
control panel.
1b.
Latches
5
1c.
Casters and other
accessories
1d.