Technical Data - Telcoma Automations ILB sincro Mode D'emploi

GB
CHARACTERISTICS
ILB consists of an emitter and a detector with double relay safety outputs and its
operation is based on infrared technology using a gallium arsenide diode.
The barrier is made by the emission of an infrared beam of light with a frequency
above 1000 Hz and detection of the same by a special infrared-sensitive
photoelement.
Interruption of the light beam causes an exchange of the relay contacts inside
the detector.
The two relays inside the detector ensure maximum safety in accordance with
regulations in force, even if one of them is damaged or in the event of power
failure.

Technical data

INSTALLATION
For wall-mounting, the plastic containers for the ILB photocell should be
embedded in the installation point.
For fixing onto a metal structure, a 60 mm diameter hole should be drilled.
In both cases, an outlet for the electrical wires must be made.
For trouble-free operation of the device, avoid installing the detector near
spotlights, triac or similar electronic controls.
15