Wireless Dmx - Algam Lighting VULKAN PRO Mode D'emploi

WIRELESS DMX

WIRELESS
DMX
Pairing your DMX fixture
1
Connect the transmitter ( Algam Lighting DMX-WT) to your DMX controller OUTPUT
2
Power up transmitter and the VULKAN PRO receiver
3
Press and hold 4 seconds on receiver button on your VULKAN PRO to reset the pairing until
the status LED becomes white.(this means that receiver is now ready to be paired).
4
Press now on transmitter button to start pairing. Both receiver and transmitter will blink rapidly
(transmitter in blue color and receiver in green color). The pairing is processing.
Once pairing is done, the transmitter status LED is now fixed blue color and receiver status LED
is fixed green color.
If Transmitter or receiver looses DMX signal, the status LED will blink slowly.
Add a fixture in an active group.
1
Press and hold 3 seconds on receiver button on your new fixture to reset the pairing until the
status LED becomes white.(this means that receiver is now ready to be paired).
2
Press now on transmitter button to start pairing. Both receiver and transmitter will blink rapidly
(transmitter in blue color and receiver in green color). The pairing is processing.
Once paring is done, the transmitter status LED is now fixed blue color and receiver status LED
is fixed green color.
The other fixtures already paired in this group with this transmitter remain paired of course.
Set up a new group
To set up a new group is very easy. You need one more transmitter of course.
Keep the existing groups active , and start the procedure above called « Pairing you DMX fixture».
Notes:
This DMX wireless system from Algam Lighting is not limited in number of groups and in number of
fixtures connected in a group.
This ALGAM LIGHTING fixture is equipped with a DMX wireless transmission system.
«WIRELESS DMX».