Ambi Fire TAURUS Mode D'emploi page 4

EN
7. Declared qualities stated in the declaration are valid for all products mentioned in the point 2:
Harmonized technical specification
Basic characteristic
Risk of falling out of burning fuel
Concentration CO in gases at 13% O
Surface temperature
Electrical safety
Cleanability
Temperature of gases of combustion at rated thermal output (°C)
Mechanical ruggedness
Nominal output (kW)
Energetic efficiency (%)
8. Manufacturer stated in point 4 declares that qualities of product listed in points 1 and 2 are in conformity with qualities
declared in point 7.
9. Other recommendation:
In case that stove is instaled in are with flamable materials all safety distance requirements must be tripled.
Description and designation of the product:
Fireplace stove for local heating of residential and social rooms.
The connection of fireplace stoves to chimney flue can be made in accordance with the directive applicable to the state where the stoves will be installed
only.
Only wood can be used as fuel. Coal, coke and household waste is forbidden to be used
The appliance may be serviced by adults only. Operation requires occasional service and supervision.
Flammable objects must not be placed on the appliance.
The appliance must be placed on a non-flammable surface The overlay of the surface from the ground plan of the stove should be at least 800 mm at the
front and 400 mm at the sides.
After every longer interruption of the operation of the stove, it is necessary to check the passage and cleanliness of the chimney, the flue duct and the
flue gas space before recommissioning.
The door must be always closed, except commissioning, refueling and ash removal.
All operating information is provided in the operating instructions manual supplied with the product.
This declaration of performance is made under the sole responsibility of the manufacturer referred to in point 4.
Olomouc, 19.12.2019
Fire safety
Distance from flamable materials
Minimal distance (mm)
Back
400
(%)
2
Marek Vajbar
Technical director
EN 13240:2002/A2:2005
According point no.2
Side Front
200 1100
Pass
0,128
Pass
Pass
Pass
287,2
NPD
7,84
71,9