Storage And Maintenance - Base Camp F235884 Instructions D'utilisation Et Manuel Du Propriétaire

4. Close the lid and rotate knob to
knob in a clockwise direction to select the length of time in minutes
that is required. See the washing guide to set the correct time.
DRAINING OPERATION
1. Once the appliance has completed the washing cycle,
unhook the drain pipe from its position on the side of the
appliance and lay on the ground below the level of the base
of the machine.
2. Allow water to drain away from the appliance
3. Return hose to its stored position
RINSING OPERATION
1. Lift the lid and half fill tub with water via either the water
inlet (A) locate on the top of the washer or (B) using a
bucket pour directly into the tub. Take extreme care not to
allow water to flow over into the control panel
(A)
2. Place articles in the tub and complete filling the tub with
water to the required level mark. Do not use washing liquid
or powder.
3. Close the lid and rotate the timer in a clockwise direction
See the washing guide for the correct rinse time.
4. Repeat the draining operation.
position then rotate the timer
(B)
Basecamp, Inc. | Portable Washing Machine
SPIN CYCLE OPERATION
1. Make sure all the water has been drained out of washer and
clothing is removed then place basket in tub.
2. Aline the basket evenly at the bottom of the tub to the 4 tab
openings then push down until you hear the 4 tabs pop into place
and turn knob to
(4)TABS
3. Place clothing in spin bucket, then place plastic cover for spin
bucket under the rim of the spin bucket and close lid. Set
the timer for up to a 3 minute max. (The bucket is smaller so
it will hold less clothing than wash mode.) When spin cycle
starts, firmly hold down the handles located on both sides of
the appliance until the spin cycle has completed.
HANDLES
ON EITHER
SIDE
to
4. Once the spin cycle has fully stopped, remove clothes hang
to dry.

STORAGE AND MAINTENANCE

When storing, ensure that all water has been removed from the
tub and that it is dry and free of clothes other articles.
With appliance disconnected from AC input all external and internal
surfaces can be cleaned with warm soapy water taking care not to
allow water to enter the control panel.
Do not use abrasive cleaners or bleach.
Do not submerge the appliance in water.
When storing for periods of time, flush out wash tub with clean
water then allow to dry completely before storing away.
4
Operating Instructions and Owner's Manual
(spin mode).
(4) TAB
OPENINGS