Leuze electronic CML 720i Mode D'emploi page 23

Beam spacing
05
10
20
40
Measurement field length
xxx
Equipment
A
R
Interface
L
CN
PB
CV
D3
PN
Electrical connection
M12
Commissioning
Mounting
NOTICE
Make sure there are no reflecting surfaces in the vicinity.
The light curtains can be fixed with three different methods with the standard ac-
cessories:
– You can mount the light curtain so it is laterally fixed using the T-groove and
sliding block.
– The swivel mount is fixed at the top and bottom of the light curtain and per-
mits 360° turning.
– The optional swiveling mounting bracket is used laterally in the T-groove of
the light curtain and permits +/- 8° turning.
– More information can be found in the chapter "Mounting" of the operating in-
structions.
5 mm
10 mm
20 mm
40 mm
Measurement field length [mm], dependent on beam spacing
Plug outlet, axial
Plug outlet rear side
IO-Link
CANopen
PROFIBUS
Analog current/voltage output
RS485
PROFINET
M12 connector
EN
23