AEG LADEGERÄT LP 10.0 Notice D'utilisation page 30

30
S
T. If the battery voltage is between 1.5 V and
3.5 V the charger will attempt to increase the
voltage within a few minutes so that regular
charging can automatically be continued. If this
fails the display will read
be suspended. However, since the equipment
detected a proper connection with the battery no
further steps may be taken. The battery is
defective and can no longer be charged!
T
Step 7: Battery voltage recognised
D, E, F. If the equipment automatically detects an
operating voltage of 6, 12 or 24 V, this infor-
mation will be shown in the display. For a 12 V
battery, for example, the display will briefly read
E
. The battery condition
Charging will start after this battery review.
E
8
Step 8: Charging
G, H, I. The respective battery voltage of 6, 12
or 24 V will briefly be displayed. The charger
will start charging and the display will read
for some time. After charging to 10 %
displayed, charging will now continue in rapid
mode until the display reads
charge has reached a level of 90 %.
T
and charging will
will also be shown.
8
G
H
will be
I
to confirm the
G
H
Step 9: Slow charging
J. Once the battery charge reaches 90 % the
equipment automatically switches to slow charge.
The remaining capacity will now be gently
charged at a lower voltage. This mode will be
J
indicated by and the battery charging
bar .
8
J
8
Step 10: Trickle charging mode
K. Once the battery is almost fully charged the
charger will activate "Trickle Charging" mode.
The voltage and amperage will now be adjusted
for the charging process. The display will read
K
.
K
Step 11: Charging complete
L. Once the battery charge is at 100 % the
L
display will read
stopped and the battery can be disconnected
from the charger. Always first disconnect the
power cable from the mains current.
Then disconnect the negative (-) black clamp
from the negative (-) battery terminal. Finally,
disconnect the positive (+) red clamp from the
positive (+) battery terminal.
L
I
. Charging will now be