Publicité
Les langues disponibles
Les langues disponibles
EN
PLEASE CAREFULLY READ
THIS MANUAL AND KEEP IT
IN A SAFE PLACE
WARNINGS/CAUTIONS
• DO NOT use the headphones at a high volume for an extended
period.
– To avoid hearing damage, use your headphones at a comfor-
table but moderate volume.
– Lower the volume of the device before placing the
headphones in or on your ears, then progressively increase
the volume to the desired level.
• Be careful and respect the applicable regulations concerning
the use of earphones and headphones with mobile te-
lephones if you use the headphones with a mobile telephone
or to make and receive calls while driving. Certain jurisdic-
tions impose specific limits regarding use while driving, such
as using only one earphone, for example. DO NOT use the
headphones for other purposes while driving.
• Be careful, consider your own safety and that of others while
you are using headphones while performing an activity that
requires your attention, particularly when you are cycling or
The manufacturer is not responsible for any damage caused by improper use.
CHARACTERISTICS
– Version Bluetooth : V5.0
– Résistance : 32 ohms
– Distance de transmission : 10 m
– Taille du haut-parleur : 30 mm
– Puissance de sortie : 100 mAh
– Temps de charge : 2 heures
– Fréquence : 20 Hz – 20 KHz
– Autonomie (voix) : entre 5 et 6 heures
– Sensibilité : 95 – 103 dB
walking on or near to a busy road, a building site, a railway,
etc. Remove the headphones and adjust the volume to be
able to hear the sounds around you, including horns, alarms
and warning signals.
• DO NOT use the headphones if they are emitting an abnormally
loud noise. If applicable, turn off the headphones and contact
your retailer.
• Do not submerge the headphones in water or expose them to
water for prolonged periods, and do not wear them to practice
aquatic sports (swimming, water-skiing, surfing, etc.)
• If you notice any heat or a loss of audio signal, immediately
remove the headphones.
• DO NOT use mobile telephone adaptors to connect the
headphones to the audio system in an airplane cabin. The
resulting heat generated could cause burns or damage the
headphones.
– Autonomie (mode audio) : entre 5 et
6 heures
– Dimensions : 40 mm
– Volume réglable
– Bouton Marche/Arrêt
4
INSTRUCTIONS
Pairing to your Device
To pair to your phone or device for the first time hold down the play button
control panel for 4 seconds until you see a red and blue flashing light. Open your settings on your
phone or device. You will see the name "Bluetooth Beanie" in the list, select it and your device
will be connected.
If a password is requested please use the default: 0000.
Next time you switch on your product, it will be connected automatically.
Taking calls
To take an incoming call press the Play/Pause button . If you
are listening to music it will automatically stop. To end a call,
press the Play/Pause button . Double click the Play/Pause
button
will re-dial the last number.
Playing music
Select your music as normal from your phone or device. Use the
buttons on your control panel to Play-Pause & Skip tracks.
Charging instructions:
Fully charge battery before first use.
Use the supplied USB cable, simply plug into the charging port of the headwear.
Now plug the other end of the USB cable into your PC or laptop.
During charging, the LED status Light will turns to be red on the control panel.
When charging is completed, the red light will change to blue.
It will take about one hour to get the battery full changed.
Buttons Interface:
Volume Down (long press) / previous Song (short press)
Play/Pause/Answer/Hang off/Redial
Power On/Power off (long press)
Play/Pause (short press)
Answer/Hang off (short press)
Redial (double click)
Volume Up (long press) / Next Song (short press)
LED Status Light / Microphone
Long press Play/Pause button for 2 seconds to reject a incoming call.
located on the
Power On
Simply hold down the Play/Pause button
for 4 seconds to
turn on.
Power off
Simply hold down the Play/Pause button
for 4 seconds to
turn off.
Wireless Headphone will shut down if connection failed in 3
minutes.
Double click button "+" to activate SIRI on ISO device.
5
Publicité
