dji SNAIL Guide De L'utilisateur page 6

Assembling the Adapters
Tools Required: M2 hex key
Remove the screws securing the Quick-Release
Propeller Adapter on the 2305 Racing Motors, the
spring and the Quick-Release Propeller Adapter if
there is any.
1. Remove the cap on the Snail Propeller Adapter.
2. Align the holes of the black Propeller Adapter
with the holes on the CW motors. Insert the M2×4
screws and tighten to secure. Align the holes of
the red Propeller Adapter with the holes on the
CCW motors. Insert the M2×4 screws and tighten
to secure.
4