Maintenance Instructions; Motor Brush Replacement; Lubrication; Tool Storage - Gap Power 700 Mode D'emploi

No. 700 Portable Power Drive
Contact a RIDGID distributor or consult the Ridge Tool
catalog for specifications and catalog numbers.

Maintenance Instructions

WARNING
Make sure Power Drive is unplugged from power
source before performing maintenance or mak-
ing any adjustments.

Motor Brush Replacement

Check motor brushes every 6 months and replace brush-
es when they are worn to less than

Lubrication

Grease face gear and bearings every 3 to 6 months
depending upon the amount of use. Grease fitting is pro-
vided on the gear housing.

Tool Storage

Motor-driven equipment must be kept
WARNING
indoors or well covered in rainy weather. Store the Power
Drive in a locked area that is out of reach of children
and people unfamiliar with power drives. This power tool
can cause serious injury in the hands of untrained users.

Service and Repair

WARNING
Service and repair work on this Power Drive must be
performed by qualified repair personnel. Tool should be
taken to a RIDGID Independent Authorized Service Center
or returned to the factory. All repairs made by Ridge Tool
Co. service facilities are warranted against defects in
material and workmanship.
When servicing this Power Drive, only
WARNING
identical replacement parts should be used. Failure to fol-
low these steps may create a risk of electrical shock or
other serious injury.
8
1 / ".
4
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: rtctechservices@emerson.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com -
pany at (800) 519-3456 or http://www.RIDGID.com