Load Limits - Yakima Landing Pad 3 Guide Rapide

Remove covers from
Landing Pads.
Attach Landing Pad to hooks.
• Insert washer and screw.
• LOOSELY engage hooks.
• Do not tighten completely.
Installation Tips:
CROSSBAR SPREAD:
The distance between the Yakima
crossbars is determined by the
accessories you wish to carry.
The Crossbar Spread Table (Fit List or
Catalog) will tell you how much crossbar
spread your accessories require.
YOU ARE NOW READY TO PROCEED TO CONTROL TOWER INSTRUCTIONS.
1033030A-2/6
Slide hooks onto track.
Engage the screw with
wrench supplied.
Base should be flush to track.
LOAD LOCATION:
For ease of loading, consider where
the most convenient placement of
your load would be before
completing the installation.
LOAD LIMITS: Limit your loads to
skis, bikes boats, gear baskets and
SpaceCadets. No long loads that
cannot be tied down at the ends!
Arrange hooks on the tracks in the
positions where the Landing Pads will be
attached.
adjustments can
Control Tower is
USE CAUTION WHEN
OPENING YOUR HATCH.
On some vehicles, hatch
interference with
accessories is unavoidable.
NOTE:
Do not fully
tighten. Final
be made after
installed.