Led Indicators - Axis T8640 Mode D'emploi

AXIS T8640

LED Indicators

LED Behavior/color
Coax Off
link
On
Flash
Orange/red
Ethernet Off
link
On
Flash
Red
PoE over Off
coax
On
Red (1 flash)
Red (2 flashes)
Red (3 flashes)
Max PoE On
power
available
Flash
for
camera
(Watts)
Orange (flashing)
Red (flashing)
Indication
No power
Connection established
Units not detected on coax
Data rate < 100%. The coax connection has
reached power and range limit. Reduce cable
distance or connect an AXIS T8003 PS57 supply
to the Device unit.
No network connection
Ethernet link established
Network activity on port
10BASE-T connection. Units must be connected
to 100BASE-T (full-duplex) compatible
equipment for effective operation.
Units not detected
PoE over Coax enabled
Low voltage. Check power supply type/polarity.
Short circuit. Check for cable faults and remove
legacy video equipment.
Power disconnected due to overload.
Max PoE power that can be reliably delivered
from 5 to 25 watts.
Less than 5 watts of PoE available.
Approaching power limit
Power limit reached. See note below.
Page 7