NINCOAIR NH90046 180 BLACK HAWK Manuel De L'utilisateur page 5

TRANSMITTER
POWER INDICATOR
UP-DOWN
CHARGING CABLE
(BACK)
POWER INDICATOR
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1.- Open the battery covers.
2.- Fit the batteries (respect polarity).
3.- Close battery covers.
Helicopter:
There are two ways to charge the battery:
1) Connect the USB cable to the USB port of a computer (preferably) or a wall charger (not included). Connect the
charging plug into the helicopter (CHA).
2) Switch in position OFF. Open the charger cable cover. Connect the cable between the transmitter and the helicopter
(CHA). Switch ON the transmitter.
HELICOPTER FLIGHT
Before flight:
1.- With the helicopter battery disconnected,
the transmitter .
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground (very important for the operation of the gyro), with the tail pointing toward you.
4. Synchronizing transmitter and helicopter: Full push the left stick for a second, then pull back.
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it to the left or the right until the helicopter stops turning.
select the band in the transmitter A, B o C and the helicopter will automatically identify it.
Switch ON the helicopter.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
5
Crta. de L'Hospitalet 32
HANDBOOK
TRI-BAND CHANNEL
TURN LEFT-RIGHT /
FORWARD-
BACKWARDS
POWER/CHARGE
SWITCH
ENGLISH
Switch ON