Troubleshooting - Parkside PMH 2400 A1 Traduction Des Instructions D'origine

Troubleshooting

Problem
Motor not running
Garden waste not
being pulled in
Machine is not sh-
redding satisfactorily Blades are worn
Possible cause
No mains power supply
Housing lock not closed
Shredding material too
soft
Cutting roll is blocked
Shredding material in
ejection chute
Troubleshooting
Check the socket, cable, line, plug,
and have them repaired by a quali-
fied electrician if necessary
Tighten housing lock by hand
Push through using wood or shred
dry branches
Release blockage (see section
"Removing blockages")
Pull out the plug, wait until blades
stop, remove shredding material
from the ejection chute
Check the blades and turn, grind or
replace if necessary (see "Turning or
replacing blades")
GB IE
33