General Instructions; Main Features - Nicols PAT 100 Manuel D'utilisation

A. GENERAL INSTRUCTIONS
Please read the enclosed instructions carefully as they include important points about
safety for the installation, usage and maintenance of the unit.
• Please keep this booklet with the unit for future consultation. If you sell the unit to another user,
be sure that the new user also receives this instruction booklet thus giving them the necessary
information about the use and general warnings regarding the unit.
• Before the initial start-up, please unpack and carefully check all components in case any damage
may have occurred during shipping.
• Locate a suitable spot for your device where there is good ventilation. Also, make sure that no
ventilating fans or slots are blocked.
• Protect our environment! Please dispose of the packing boxes properly.
• The electrical work that is necessary for installation must done by qualified personnel.
• Always remember to unplug the unit from the main power before any service is done. Do not open
the unit. There are no serviceable parts inside.
• It is very important to ground the yellow/green conductor to earth in order to meet regulations for
safety.
• Check the surrounding area and make sure there are no flammable liquids, water or metal objects
that could enter the fixture. If a foreign object enters the unit, immediately disconnect the main
power. Also, place the fixture in a well-ventilated room at about 15 cm from the walls.
• Do not touch any wires during operation, as high voltage is hazardous.
• In the event of serious operating problems, stop using the unit immediately. Never try to repair the
unit yourself. Repairs carried out by unqualified personnel can lead to damage or malfunction.
Please contact the nearest authorized Technical Assistance Center. Always use genuine spare
parts.
B. MAIN FEATURES
• Voltage：AC 230V 50Hz
• Bulb： EFP 12V 100W
• The unit is a DMX512 scanner. It features full DMX512 control, 10 gobos/colors plus open and
white, focus adjustable accurate optics system and stepper motor with blackout feature. Fan
cooled.
• It can be operated by DMX512 control or can be used as an individual unit without controller.
• It can be linked together as many as required in master/slave mode, and perform the great built-in
programmed lighting shows triggered by music.
• Please use a 3 pin XLR cable/plug when connecting them together.
• It features different pre-programmed chase patterns.
• Dimensions：385 mm x 170 mm x 122 mm / 15.15 in x 6.69 in x 4.8 in
• Weight：3.8 kg / 8.4 lbs
Distributeur : Page 9A