Correction Of Malfunctions; Technical Data - Romus STEAM MASTER Mode D'emploi

Malfunction
Unit fails to boil
Unit keeps cutting out
Steam escaping from pressure
cap
If the unit still will not operate return the unit to the dealer or authorized agent for investigation.
Power source:
Steaming time:
Boiler capacity:
Max persons:

CORRECTION OF MALFUNCTIONS

Cause

The thermal cut-out has
operated

Usage of an extension
lead

Water is below MIN
level

Usage of an extension
lead

Additives have been
used

Blockage in hose or
steamplate

Build up around cap
area

TECHNICAL DATA

220-240 V ~
Power consumption:
50 Hz
80/195
minutes
7,5 L
1 Max standing weight:
22
STEAM MASTER| Réf. 194550
Remedy
 Switch off, allow to cool, refill
with water then switch on again
Check that the thermal reset
button has not tripped out.
Check that the extension lead
is rated at minimum of 15 Amps
(EU)/ 13 Amps (UK) - 230V unit
only and fully unwound.
Refill water
See above
Refresh water
Remove blockage
Clean seating around cap
area
Hose length::
Unit weight:
GB
2750 W
5 m
9,4 kg
127 kg