Automatic Registration - Hama 00040617 Mode D'emploi

To find the best possible location for the repeater,
you have to try different locations. Establish a call
and walk around with the handset to determine the
base stations coverage area. You can install the
repeater at a location, in the edge of the coverage
area, where you still have a good connection bet-
ween the handset and the base station. A new
coverage area will now be available around the
repeater.
Note: The LED must remain on constantly after the
device has been switched on.
If the LED flashes, the repeater is too far away from
the base station or reception is being hindered by
thick walls or metal objects (e.g. radiators)
Verification tone
The verification tone enables you to establish
whether or not the mobile unit is working in the
extended area of the repeater. This tone is audible
on the activated mobile unit as long as the unit is
connected to the repeater.
Carry out the procedure described below on your
repeater in order to switch the verification tone on
and off:
- Switch off the unit (disconnect the power plug)
- Switch on for 1-5 seconds and switch it off again.
- Switch on again. The LED on the unit is flashing
slowly, switch off again.
- Switch it on again. The verification tone is then
activated or deactivated.
Maintenance
Simply wipe the repeater with a damp cloth or an
antistatic wipe.
Never use solvents or a dry cloth (static discharge).

Automatic Registration

Base station
Switch on
Basestation
Press Registration
Page key
Repeater
Switch on
Repeater
LED flashes
Repeater
LED steady on
Ready for use