Safety Instructions - Aguilar Tone Hammer 500 Mode D'emploi

I. Safety Instructions
WARNING: To reduce the risk of fire or electric shock, do not expose
equipment to rain or moisture. Aguilar Amplification assumes no
responsibility for any damage or injury that results from improper use
or service.
CAUTION: RISK OF ELECTRIC SHOCK! DO NOT OPEN! There are no user
serviceable parts inside of this product. This is a high voltage device,
and internal voltages can be lethal. Any and all work should be
performed by qualified personnel only.
In order to ensure safe operation of the device, please follow these guidelines:
1. Read the instruction manual in its entirety before trying to operate the
equipment. The manual should be kept for future reference.
2. Observe all safety precautions, warnings and instructions noted in this manual.
3. Always unplug the amplifier out of the wall socket, before cleaning. Use
only dry cloth. Do not use aerosols or solvents.
4. Keep the device away from sources of water such as pools, bathtubs, and sinks,
and do not expose it to rain or splashes of water. Do not place objects filled with
fluid on the device.
5. Vents are provided for heat dissipation on the sides, and at the rear of the
amplifier. Maintain at least a 2" (5cm) space around these vents to provide
sufficient ventilation.
6. Keep the amplifier away from sources of heat and open flame, such as
heaters, radiators, stoves, lit candles, etc.
7. Make sure that the power cord is intact before plugging it into the unit. Do not
use cords with visible damage to its insulation, or connectors.
8. This device is equipped with a safety feature that requires the use of the three-
pin grounding power plug. Do not defeat the safety purpose of the grounding
plug. If provided plug does not fit your outlet, consult an electrician about
replacing an obsolete power outlet.
9. Use only accessories listed in this manual, or in other way specified by the
manufacturer.
10.Do not install this amplifier on carts or other moving objects.
11.When amplifier is in use, route the power cable in such way that will prevent it
from being stepped on, tripped on, pinched or damaged in any other way.
12.Do not use this device with wall/ceiling mounts not specified by the
manufacturer.
13.To completely discontent the equipment from the AC mains, disconnect the
power cord from the AC receptacle. For additional protection, unplug the
device during light storms, or when not used for long periods of time.
14.No user serviceable parts inside. Refer service to qualified service
personnel. If the unit was exposed to liquid, extensive heat or fire, or
sustained a mechanical damage of any kind, do not attempt to
operate it. Disconnect the unit from the wall outlet, and consult
qualified service personnel.
Page 2