Panel Description - KIKKA BOO SERENITY Mode D'emploi

Masquer les pouces Voir aussi pour SERENITY:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
II.

PANEL DESCRIPTION

1. Level Display; 2.Working Indicator Lamp; 3. Auto Mode Key; 4.Bionic Mode Key; 5. On/O Key; 6.Full Energy Display; 7. Medium
Energy Display; 8. Low Energy Display; 9. Memory Key; 10. Milk Pumping Mode Key;
III. ASSEMBLY MODE
Before you start assembling a breast milk pump, please wash your hands and be sure to sterilize all components prior to use.
1. Press the anti-leak valve suction sheet onto the anti-leak valve; and there should be clearance in tting (The small semicircle bump
on the anti-leak valve suction sheet should be aligned with the semicircle hole on the anti-leak valve) (as shown in Fig.1). (This silica
gel sheet is very important, and if it's not installed or not installed correctly, there will be no suction.)
2. Fix the anti-leak valve on the breast milk pump's tee and press to the end (as shown in Fig.2).
3. Mount the horn-mouth silicon massage pad onto the breast milk pump's tee and make sure it coincides with and clings to the
pump's cup (as shown in Fig.3).
4. Put the cylinder into the breast milk pump's tee and then tighten the top cover (as shown in Fig.4).
5. Screw the milk bottle into the breast milk pump' s tee (as shown in Figure 5).
6. Insert the suction pipe into the small column on the suction hole of the top cover, and the other part of the suction tube into the
silica gel hole of the main unit to ensure full insertion. (as shown in Figure 6)
7. Insert the USB cable into the adapter and the other end into the panel. Complete the following steps at any time (as shown in
Figure 7)
8. After the breast milk pump is completely assemble, it' s ready for use at any time. If it is not necessary to feed your baby in time, you
can store the milk in the refrigerator and nally clean the breast milk pump' s components immediately to prevent the milk from being
dried and xed on the components so that it' s hard to clean (as shown in Fig. 8).
[ON/OFF Key] Press this key to enter Auto Mode 1 by default, and then press it again to turn o the machine.
[Battery Energy Level Display] It is displayed when the adapter is being used or during charging. When the adapter is not connected,
the current energy level will be displayed. In case of low energy, it will ash and then the machine will be turned o automatically.
[Level Display] Display the level of the current working mode.
[Auto Mode Key] There is 1 to 8 suction levels for selection. The power-on default is to enter the Auto Mode Level 1. When you touch
once, it is con rmed as being always at this level. If you touch this key again, it will switch back to the Auto Mode. In the Auto Mode,
the level is one step up per minute of working, up to Level 8.
[Bionic Mode Key] There is 1 to 8 suction levels for selection. After you touch the bionic key, the machine will enter
Level 1 of this mode. The suction force will increase by one step per touch and such a cycle goes back and forth.
[Milk Pumping Mode Key] There is 1 to 8 suction levels for selection. After you touch the milk pumping key, the machine will enter
Level 1 of this mode. The suction force will increase by one step per touch and such a cycle goes back and forth.
[Memory Key] Hold on this key for 2 seconds to memorize the current level. The next time you use it, you can quickly enter the
memorized level. Hold it on again to cover the previous memory.
HOW TO USE THE BREAST MILK PUMP
1. It is recommended that you apply a hot compress on your breast for 5 minutes before use to promote the smooth ow of your
mammary gland for better and more e ective breast milk pumping.
2. Make sure that the components of the breast milk pump are thoroughly sterilized and that the breast milk pump is properly
assembled as instructed. When using, please maintain a comfortable sitting position and relax, align the cup center of the breast milk
pump to your nipple and hold it against your breast. Make sure no air enters to ensure a normal suction force.
3. Touch the ON/OFF key to enter the Auto Mode Level 1 by default to stimulate and massage your mammary gland. If you need to
increase the suction force, you can touch the key again.
ENGLISH

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

31304010004

Table des Matières