AUTO-HAK X08 Mode D'emploi page 5

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
9
7
16
8
4
This tow bar is designed to assembly in following cars:
DAEWOO LANOS 3/5 doors, produced since 06.1997 till 01.2004,
catalogue no. X08 and is prepared to tow trailers max total weight 1100 kg
and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of tow bar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The tow bar should be install in points described by a car producer.
6
8
11
1
11
10
2
3
From manufacturer
9
1. Disassemble the rear plastic panel's cover in the boot
2. Put the template "A" on supports of the boot (left and right side), then sign
huge hole according to this template and drill it.
3. Unslide the fuel pump and dismount the runner.
4. Being at the bottom of car drill 12 mm through original holes (apparently 20
mm) of chassis members to the inside part of the boot (two holes per each
side, do it very careful)
5. Enlarge this holes fi 25 mm (do it inside of the boot) and next slip to this
holes distance sleeves, see fig. 2
6. Put fish plate (pos. 6 and 7) in that way so holes in elements (pos. 6 and 7)
agree to early make holes.
5
7. Put elements (pos. 4 and 5) at the bottom of car and fix it through distance
sleeves and elements pos. (pos. 6 and 7) using bolts M12 x 100.
8. Fix bar of tow bar (pos. 1) through holes (pos. B) using M12x35mm to
mounted elements (pos. 4 and 5)
15
9. Reassemble fuel pump` s runner through the hole signed at the fig. 3, then
slide fuel pump and fix it to the handle of body car using link (shape of link is
as the letter "Z") (pos. 17) from the car equipment
10. Reassemble rear plastic panel cover. Fix tow-ball (pos. 2) and socket plate
(pos. 3) using bolts M12x75mm (pos. 10) from equipment.
11. Tighten all bolts according to the torque shown in the table.
12. Connect electric wires of 7-bolts socket according to the instruction of the
car. (Recommend to make at authorized service station)
13. Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of tow bar must
be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm