Cerdi PCI 40 Manuel page 6

PCi100
The PCi 100 is designed for a three-phase outlet
400Vac / 50 Hz. The electrical power source
must conform to local electric code with
adapted
circuit protection. Connect the electrical ground
wire (yellow-green) to the earth lug then
connect
the three-phase wires to the line voltage L1, L2
and L3. If doubt seek advice.
1
2
3
4
5
CUTTING
A. Connect the earth cable to the PLUS-Pole and the work piece
B. Connect compressed air to rear of the cutting machine (4-6 bar)
C. Adjust the current following thickness and desired cutting speed
Cerdi Bvba
BOM
1. Current Display
2. Indication Pressure
3. Current adjust 20-
100A
4. Torch Connector
5. Mass Clamp
6. Pilot Switch (option)
8
10
11
9
7
6
Handleiding PCi40-100
7. LED low pressure
8. LED On
9. LED Temperature
10.Load Switch
11. Pressure inlet (5.0-5.5 bar)
12. Power Cable (400V 3ph)
12
2
info@cerdi.be