Arrow GSFK6 Guide Rapide page 2

INSTRUCTIONS Continued
PART 2: EYELET/STUD INSTALLATION
STEP 1
Place Eyelet (C) flat side down on Anvil (E) over firm work
surface. Center hole in material over Eyelet stem (C).
(C)
STEP 2
(E)
Place Stud (D) rounded side up tightly over Eyelet stem (C)
and material.
STEP 3
Place bottom of Flaring Tool (F) over Stud (D). Strike firmly
with hammer until Eyelet (C) and Stud (D) fit tightly to
material. Keep Flaring Tool straight when striking.
Snap Cap and Stud together to assure proper
fastening.
(F)
(D)
WARNING! This product contains one or more chemicals known to the state of
(C)
California to cause birth defects and other reproductive harm and/or cancer.
These tools are not intended for extensive commercial or industrial
(E)
use. Using them in this manner for an extensive period may result in property
damage or personal injury.
Manufacturer assumes no responsibility for any product failure due to improper use
or use inconsistent with these instructions.
Made in China
©2017 Arrow Fastener Co., LLC
Arrow and GSFK6 are trademarks of Arrow Fastener Co., LLC
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, New Jersey 07663
www.arrowfastener.com
For the GSFK6 manual translation in French and Spanish please visit www.ArrowFastener.com
Pour le manuel de GSFK6 traduit en Français et en espagnol veuillez visiter www.ArrowFastener.com
Para el manual de GSFK6 traducido en francés y en español por favor visite www.ArrowFastener.com
GSFK6
TM
SNAP FASTENER KIT
PRODUCT WARNINGS:
Wear Safety Goggles. The failure to do so may result in personal injury.
To avoid personal injury, always wear OSHA/ANSI approved
eye protection (goggles, face shield) when using tools.
PMGSFK6-8n Rev 1216