Before Putting The Machine Into Operation; Technical Data - HERKULES DS 405/1E Mode D'emploi D'origine

Anleitung DS 405-1 E:Anleitung DS 405-1 E
GB
not loosen your grip at any time.
Never leave your workplace without switching off
the saw first.
DO NOT ALLOW YOUR FAMILIARITY WITH
THE SAW TO TURN INTO CARELESSNESS. IT
TAKES ONLY FRACTIONS OF A SECOND FOR
CARELESSNESS TO RESULT IN SERIOUS
INJURIES.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
Cutting
Sound pressure level LPA 74,5 dB(A) 62,7 dB(A)
K uncertainty
pA
Sound power level LWA 87,6 dB(A) 75,7 dB(A)
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.

5. Technical data

Asynchronous motor 230 V
Power rating
Operating mode
Idle speed n0 400-1600 rpm
Protection type
Stroke
Tilting table 0° to +45° to the left
Table dimensions 410 x 253 mm
Blade length
Throat depth
Cutting height max. at 90°
Cutting height max. at 45°
Weight
12
07.12.2010
6. Before putting the machine into
operation
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
6.2 Mounting the saw on a workbench Fig. 2
2
Saw body
Idling
Foam rubber mat
Work table
3 dB
Gasket
3 dB
Washer
Hex nut
Lock nut
Hex screw
1. It is better to mount the saw on a solid wood
50 Hz
workbench rather than on a weak plywood stand
120 W where vibrations and noise are certain to be a
nuisance.
S2 5min.
2. The tools and hardware needed to mount the
IP 20 saw on a work bench are not supplied with the
saw. Be sure to use equipment of at least the
21 mm
following size:
Item
127 mm
Hex screws M8
406 mm
Gaskets Ø 8 mm
Washers Ø 8 mm
57 mm
Hex nuts M8
27 mm
12 kg
9:26 Uhr Seite 12
Quantity
4
4
4
8