gdw 1103 Instructions De Montage page 7

Trekhaken
T44
Tekening 1
Dessin 1
Drawing 1
Zeichung 1
T36
Tekening 2
Dessin 2
Drawing 2
Zeichung 2
Bouten – Boulons – Bolts - Bolzen
Kwaliteit 8.8
M6 ≡ 10,8Nm of 1,1kgm
M12 ≡ 88,3Nm of 9,0kgm
Bouten – Boulons – Bolts - Bolzen
Kwaliteit 10.9
M6 ≡ 13,7Nm of 1,4kgm
M12 ≡ 122,6Nm of 12,5kgm
Attelages
Uitsnijding bumper:
Découpe pare-choc
Excision bumper:
Ausschnitzung Stoßstange:
M8 ≡ 25,5Nm of 2,60kgm
M14 ≡ 137Nm of 14,0kgm
M8 ≡ 35,3Nm of 3,6kgm
M14 ≡ 194Nm of 19,8kgm
Anhängevorrichtungen Tow bars
≡ het gearceerde gebied moet weggesneden worden
"B" = de bumper
"O" = de onderrand van de bumper
"M" = het midden van de bumper
≡ la zone hachurée doît être découpée
"B" = le pare-chocs
"O" = le bord inférieur du pare-chocs
"M" = le milieu du pare-chocs
≡ the hatched area has to be cut away
"B" = the bumper
"O" = the lower rim of the bumper
"M" = the middle of the bumper
≡ das schraffierte Gebiet muß weggeschnitten werden
"B" = Stoßstange
"O" = Unterrand Stoßstange
"M" = der Mitter von Stoßstange
DIN 912 - DIN 931 - DIN 933 - DIN 7991
M10 ≡ 52,0Nm of 5,30kgm
M16 ≡ 211,0Nm of 21,5kgm
DIN 912 - DIN 931 - DIN 933 - DIN 7991
M10 ≡ 70,6Nm of 7,20kgm
M16 ≡ 299,2Nm of 30,5kgm