LED's work 700352 Mode D'emploi page 5

LED's work
05 Security related information
When using the product, make sure the unit is sufficiently ventilated, never cover the unit
during operation and keep it out of reach of children or animals. This product is not a toy,
LED lights are extremely bright and looking directly at the light source during operation can
lead to serious eye damage. Any other use of the device than described in the manual may
damage the product or cause danger to the user, e.g. due to a short circuit, fire or electric
shock. The safety instructions must be observed at all times.
06 Conformity of the product with legislation
The warranty expires in the event of damage due to non-compliance with the safety in-
structions of the device. Furthermore, we are not liable for consequential damage, damage
to objects or persons resulting from failure to observe the safety instructions and improper
use/handling of the device due to wear and tear. Product design and specifications are sub-
ject to change without notice. All logos and trade names are registered trademarks of their
respective owners and are hereby acknowledged as such.
07 Storage of the Manual
Please read the operating instructions carefully and completely before use. The operating
instructions are part of the product, they contain important information on the commission-
ing and handling of the device. Keep all enclosed operating instructions for future reference.
If the device is sold or passed on to third parties, you are obliged to pass on the operating
instructions as these are lawfully part of the product.
08 Use of the product / Installation
Before use, check the completeness of the parts supplied and the intactness of the product.
If damaged, it must not be put into operation.
1. Charge this product completely before the first use. NOTE use a maximum of 5V 1A charger.
2. When the work light is fully charged (~ 4 hours) the green LED indicator wil light up.
3. After use, store the head torch indoors. Avoid storage in extremely high or low tempera-
tures, as this will negatively affect the lifespan of the battery. Note: if the head torch is
stored longterm (>6 months), charge it regularly. This will prevent deep discharge of the bat-
tery. As this is normal for Lithium-Ion batteries, a deep discharge does not form grounds for
a refund or reclamation.
4. NOTE: When replacing the battery: only use original 18650 cell Li-ion batteries from repu-
table brands with overcharge protection.
Operation:
1. Press on/off button 1st time for the spot mode (high beam)
2. press on/off button 2nd time for wide beam mode
3. Press on/off button 3rd time for the spot and wide beam mode
4. Press on/off button 4th time to switch off the light
5. Press sensor button to switch on the wave sensor
6. Press the sensor button for the 2nd time to switch off the wave sensor
09 Operating the product
The safety instructions and warnings must be observed to ensure both the perfect condition
of the product and safe operation.
5