Hkoenig DFX500 Manuel D'utilisation page 12

button that is located on the inside of the control panel
(Fig. 8)
Re-assemble the control panel to the housing of the
4.
deep fryer and then you may resume frying.
TROUBLESHOOTING
PROBLEM
The fryer is
1.
is not installed correctly.
not
operating
2.
connected to the electrical
wall outlet.
3.
is not energized.
4.
Oil is
1.
reservoir.
spilling out
2.
of the deep
3.
fryer
often and is foaming.
Food is
1.
tasting
2.
soggy or
greasy
Food
1.
not
2.
3.
cooked
complet
ely
1. The oil has been used too
The cooking oil
often.
is foaming or
emitting smoke
POSSIBL
E
The control assembly
The plug is not
The electrical outlet
The reset switch has tripped.
Too much oil in the oil
The food basket if overfilled.
Oil has been used too
Oil is not hot enough.
The food basket is overfilled.
Food pieces too large.
Cooking time too short.
Oil temperature too hot.
CAUS
Re-attach the control panel assembly
1.
Insert the plug into the electrical wall
2.
outlet.
Reset circuit breaker or replace fuse.
3.
Turn the appliance off and let it cool
4.
completely. Then remove the control
panel and press the thermostat reset
button
Turn the deep fryer off. Let the oil
1.
cool completely and remove some of
the excess oil.
Remove some of the food from the
2.
basket.
Turn the deep fryer off. Let the oil cool
3.
completely and refill the oil reservoir with
new oil.
Adjust the temperature control dial to
1.
appropriate temperature for food being
fried.
Remove some of the food from the
2.
basket.
Cut the food into smaller pieces.
1.
Continue frying and check the
2.
process continually.
Lower the temperature of the oil to allow
3.
the
food to cook completely.
1. Let the oil cool completely and replace
with new
oil.
E