Safety Instructions - Stalgast 9700200 Notice D'instruction

Thank you for purchasing our product. Please carefully read this instruction manual before fi rst use.
Reproduction of this manual without the consent of the manufacturer is prohibited.
The photos and drawings are for illustrative purposes only and may differ from the purchased device.
CAUTION: The manual should be kept in a safe place, available to the staff. The manufacturer reserves the right to change
the technical parameters of the device without prior notice.

1. SAFETY INSTRUCTIONS

• Caution! If the device was damaged during transport it should not be connected!
• Incorrect operation and improper use may result in serious damage to the device or injuries to persons.
• The device should only be used for the purpose for which it was designed.
• The manufacturer assumes no liability for any damages caused by incorrect operation and improper use of the device.
Failure to follow this instruction may cause life-threatening situations.
2. TECHNICAL DATA OF THE DEVICE
Model
Width
Depth
Height
3. INSTALLATION
Before fi rst use, please remove the protective fi lm from the station. Wash the external surfaces with a cloth soaked in warm
water and a degreasing agent, and then dry. Do not use agents which could scratch the surface.
The station should be set on a worktop or a stable, leveled base (it is recommended to use the bases manufactured in
Stalgast Radom Sp. z o.o.). If necessary, the station can be further leveled with adjustable feet underneath its housing (Fig. 2).
Do not lean against the extended drawer. The maximum allowable load of a single drawer is 25kg. Overloading the drawer
may result in damage to the drawer and, in extreme cases, injury to the operator.
Large drawers (used in items 9700410 and 9700610) are equipped with a bracket (Fig. 3) allowing placement of GN1/1
containers in the drawer (as in Fig. 4). The bracket is inserted loose into the slot (Fig. 6) in the rear of the front panel and in
the notch (Fig. 7) in the rear wall of the trough. Use of the bracket is optional according to user needs.
Designation
(Fig.1)
L [mm]
B [mm]
H [mm]
Figure 2. Leveling the station
Figure 3. GN bracket
Neutraler Aufsatzboard
9700200 9700400
9700210 9700410
400 800
700
250
Figure 4. Drawer with a mounted GN bracket
- 7 -
9700600
9700600
1200