Important Safety Instructions - Tripp-Lite SRFAN1U Manuel De L'utilisateur

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation
of the product described in this manual. Read all instructions and warnings thoroughly before attempting
installation. Failure to comply may affect the warranty and cause property damage and personal injury.
• Install in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive
contaminants, dust and direct sunlight.
• Inspect the shipping container and the unit for shipping damage. Do not use the unit if it is damaged.
• Connect the unit to an outlet that is provided with appropriate overcurrent protection.
• When using tools, use eye protection and follow all other safety precautions recommended by the tool manufacturer and required by
applicable regulations.
• Keep hair, clothing and loose objects away from the fan intakes. There is a risk of property damage and personal injury.
• Do not block, cover or insert objects into the openings of the unit.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of
a flammable anesthetic mixture with air, oxygen or nitrous oxide.
Installation
1
Identify the desired 1U space within a rack enclosure to mount
the SRFAN1U.
2
Align the mounting ears located on the front panel of the
SRFAN1U with the rack enclosure's front vertical mounting
holes.
Note: The SRFAN1U's fans will push air toward the top of the
enclosure.
3
Attach and secure the SRFAN1U to the rack enclosure with
user-supplied hardware.
Note: The user must determine the fitness of hardware before
mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure for
a solution.
4
Plug the input cable into a power source that supports a
NEMA 5-15P plug, such as a wall outlet, power distribution unit
(PDU) or uninterruptable power supply (UPS).
1
2
3
4
2