Operating instructions
Using OSD controller
Setup menu can be accessed and controlled by OSD control joy stick on the gimbal of
the camera unit. Five commands are available with the joy stick.
The design of OSD could be di erent according to the Model.
Description of the OSD control operation
1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down.
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up
or down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
If OSD menu is adjusted in speci c video format, adjusted value is applied to only
i
related video format. For example, if the menu is adjusted in CVBS mode, adjusted
value is applied to CVBS video only.
Video format DIP Switch
Video Sub-out connector
Using Video Format Switch
DIP SWITCH setting
If the switch is set to CVBS, only CVBS output is available for both main video output
and sub-out. Please be advised that camera generates only one video output for both
main video output and sub-out. It takes 3~5 seconds when video format is changing.
The default DIP SWITCH setting is CVBS mode.
HD
CVBS
OSD Control &
Video format Joystick
11
EN