KLASS Fan LANZAROTE LT Instructions D'utilisation page 18

2
- Remove the screw and bolt from the
hanger ball. Remove the "R" pin and
cross pin from the downrod.
- Put the canopy and the decorative
cover into the downrod, then thread
the wire through the downrod.
- Install back the screws and bolt to
the hanger ball, ensure to fasten the
screws.
Insert the downrod into the coupler,
loosen the two setscrews in the
downrod support. Install back the
cross pin and secured with the "R" pin.
Fasten back the two setscrews .
- The "R" pin must be properly installed
to prevent the cross pin from working
loose.
3
- Fixing blade to the motor assembly
with the screws.
- Repeat step for all blades.
4
Hang the fan motor housing on the
mounting bracket, ensure the ball joint
locating the groove aligns with the
notch on the mounting bracket.
downrod
hanger ball
canopy
downrod
decorative
cover
R pin
screw
Notch
Locating groove
16
screw
hanger ball
pin
power cord
canopy
cover
coupler
cross pin
Motor assembly
Blade
Screws