Starting The Water Pump - BE WILDLAND Serie Mode D'emploi

STARTING THE WATER PUMP

Starting the Water Pump
Use the following start instructions:
1. Fill Engine with Oil, SAE 10W30
2. Make sure unit is on a flat, level surface and pump chamber is primed.
3. Turn fuel valve (1) to "On" position. The fuel valve handle will be
vertical (pointing toward the ground).
1
4. Push on/off switch (2) to "On" position.
5. Move engine speed lever (3) to "Fast" ( ) position.
3
6. Move choke lever (4) to "On" position.
4
7. Grasp recoil handle and pull slowly until slight resistance is felt.
Then pull handle rapidly to overcome compression, prevent kickback
and start engine.
Starter cord kickback (rapid retraction) can result in
bodily injury. Kickback will pull hand and arm toward
engine faster than you can let go.
Broken bones, fractures, bruises, or sprains could
result.
• When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
WARNING
2
17