Simfer FS 5031-1 Manuel De L'utilisateur page 11

15. If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical
service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
16. Make sure the plug is inserted firmly into wall
socket to avoid sparks.
17. Do not use steam cleaners for cleaning the appliance,
otherwise electric shock may occur.
18. An omnipolar switch capable to disconnect
power supply is required for installation. Disconnection
from power supply shall be provided with a switch or
an integrated fuse installed on fixed power supply
according to building code.
19. Appliance is equipped with a type ''Y'' cord cable.
20. Fixed connections shall be connected to a power
supply enabling omnipolar disconnection. For appliances
with over voltage category below III, disconnection device
shall be connected to fixed power supply according to
wiring code.
11