iOttie Aivo CONNECT Manuel De L'utilisateur page 5

Using the Automatic Mounting System
Mounting and Charging
1. Side arms on mount
automatically open via
silent step motor when
phone is detected in front
of Proximity Sensor on
mount.
Releasing Device
! The Aivo Connect is powered via a USB-C cable and coin cell phone
battery. There is no on/off switch on the device. Once plugged in,
the device will remain on unless the vehicle shuts off power when in
parking mode.
! Backup battery will continue to operate the Aivo Connect cradle arms
(open & close) after power has been disconnected or turned off.
2. Once phone is placed
in mount, arms will
automatically close
after one second. Qi
wireless charging will start
immediately.
3. Buttons behind cradle
arms on both sides of
device can open and close
the arms. One or both
buttons can be pressed.
Qi Alignment Guide
The Qi Receiver Coil is generally located in the center
area of the phone. Check with your phone's manufactur-
er for specific Qi coil location. Below are some examples
for commonly used phones.
! The Qi coil on the mount is located in the center,
in between the arms and around the Infrared Proximity Sensor
iPhone 11
Aivo Connect
Samsung
Galaxy S20
Aivo Connect
! CAUTION: If device flashes red a foreign object is detected and device
must be removed to prevent overheating.
iPhone 11 Pro Max
iPhone 11 Pro
Samsung Samsung
Galaxy S20+ Galaxy S20 Ultra