First Step; Unfolding Steps - Sparco SEM1 Manuel D'utilisation

FIRST STEP

1 Battery-Connector
The battery-connector will be unplugged before
the transport to avoid any damage on the battery.
Simply grab both ends of the 2 cables and stick
them together via the direction printed on
both connector-ends.
2 Check all screws
Before starting the scooter make sure that all
screws are tightened. Especially the screws for
the accelerator + the brake can loosen up a bit
during the transport. All screws can be checked
with a conventional screwdriver + hexagon.
6

UNFOLDING STEPS

1 Release the folding lever
A
Lift the steering pipe slightly and press the
folding button at the same time. The direction
is indicated on the above picture.
B
Raise the steering pipe until the location
pin reaches the location shown on the above
picture.
2 Unfolde the handlebars
A
Push the handlebar in the direction of the
arrows. The folding lock locks automatically
when reaching the 90º angle.
B
After assembling the handlebars, make sure
that the folding locks on both sides are fully
inserted.