Computer Installation - Tripp-Lite B021-000-19-HD2 Manuel Du Propriétaire

Installation
Refer to the installation diagrams below as you perform these steps.
Note: Make sure the power to the computer or KVM switch being connected to the console is powered off before proceeding with the installation.
1
Using the included cable kit, connect the DVI connector marked CONSOLE to the DVI port on the back of the console.
2
Connect the DVI connector marked SERVER to the DVI port on your server or KVM switch.
Note: If you are connecting to a computer with a VGA port, use the included DVI-I to VGA adapter. If your server or KVM switch uses a DVI-D port, you will need a
DVI-I to DVI-D adapter such as Tripp Lite's P118-000 (sold separately). To connect to a server or KVM switch that uses an HDMI port, you will need a DVI to
HDMI adapter, such as Tripp Lite's P132-000 (sold separately).
3
Connect the USB connector on the SERVER side of the included cable kit to a USB port on your server or KVM switch.
Note: Although KVM switches contain two USB console ports for keyboard and mouse, you can plug the cable kit's USB connector into either port.
4
Remove the USB covers from each of the pass-through USB ports. Connect the pass-through USB port on the back of the console to a
USB port on a computer or KVM switch using a USB A male/male cable, such as Tripp Lite's UR020-Series. Connect a USB device to the
pass-through USB port on the front of the console.
Note: The pass-through ports do not connect to the internal components in the console (keyboard, touchpad or console).
5
Connect the power cord to the socket on the back of the console, and then plug it into a Tripp Lite Surge Protector, Power Distribution
Unit (PDU), or Uninterruptible Power Supply (UPS).
6
Power on the connected computer or KVM switch.
7
Turn on the LCD screen by pressing the On/Off button on the control panel of the built-in monitor.

Computer Installation

Note: The diagram below shows the connection of a computer with USB keyboard and mouse ports. To connect to a PS/2 computer, use a PS/2 to
USB adapter such as Tripp Lite's 0DT60002 (sold separately).
5
Computer Installation
KVM Installation
Note: The diagram below shows the connection of a B042-016 KVM switch. The console ports of different model KVM switches may be located elsewhere on
the unit.
5
KVM Installation
Specifications
Function
Console
Cable Kit
Connectors
Power
Comm.
LCD Resolution
Environment
Housing
Weight
Dimensions (L x W x H)
4 1
4 1
Specification
1 x DVI-I female
1 x DVI-I male to 1 x DVI-I male, 1 x USB male
1 x IEC-60320-C14 AC socket (100-240V~, 50/60Hz)
1 x USB (Type A to Type A)
1920 x 1080; DDC2B
Operating Temperature: 32° to 104° F
Storage Temperature: -13° to 140° F
Humidity: 20 - 90% RH Noncondensing
Metal
27.78 lbs.
27.28 x 18.78 x 1.7 in.
2
3
3
2
3