Sanus CAFQ01 Manuel D'instructions page 6

C-Front
OPT
2 Plug in Fan
6
Mount the fan [01] at the top 3U location on the front rails of the rack
using four 10-32 x ¾ in. screws (not included). It is usually mounted
directly above the CAPT01 SANUS EcoSystem™ Multi-volt Power Supply.
[01]
(CAPT01)
Note: CFR21XX Series rack shown
[02]
Make sure the master power
switch of the CAPT01 SANUS
EcoSystem™ Multi-volt Power
Supply (CAPT01) is in the off
position. Plug one end of the
power cord [02] into the fan's
[01] jack and the other end
into one of the CAPT01's 12
Volt power jacks:
 For continuous operation,
plug the power cord into
one of the "ALWAYS ON"
jacks of the CAPT01.
 For control by the
thermostat, plug the
power cord into one
of the "THERMOSTAT
CONTROLLED" jacks of the
CAPT01.
Refer to the instructions for the
CAPT01 for more information
regarding powering the fan.
6901-002140 <00>
[01]
3U