MA lighting grandMA3 Mode D'emploi page 24

7. To make basic settings, turn the rotary knob on the front panel of the device.
8. To turn off the grandMA3 xPort Node DIN-Rail, disconnect the RJ45 connector or the terminal block connector.
Update the software
1. To update a grandMA3 device, download the latest software version from www.malighting.com.
2. The required installer is called grandMA3 Software x.x.x.x.
3. Extract the zip file and copy the folders EFI, ma, and the update.scr file into the root directory of your USB flash drive.
4. Insert the USB flash drive in the device's USB port.
5. Turn off the grandMA3 device.
6. Power up the grandMA3 device.
7. Follow the onscreen instructions during the update process.
Important:
To configure the device, or to update or downdate the installed software, use a grandMA3 console or your PC or laptop
with the grandMA3 onPC software installed. For more information see the topics Control other MA Devices and Update
the Software via Network Update in the grandMA3 User Manual online available at www.malighting.com.
24
Intended Use
Safety
Support
Transport
Limitations
Installation
Quick Start
Maintenance
Disposal
Technical Data
Declaration of Conformity