Spare Parts; Technical Data - Hansgrohe Allegra Talis'E 33820000 Notice De Montage

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metall without the
plastic washer.
4. Tighten screws.
5. Connect the connecting hose to the angle
valves; cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.

Technical Data

Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a
continuous flow water heater.
6
English

Spare parts

1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5
6 aerator cpl. (10)
7 fixation set
8 connection hose 600 mm
9 connection hose 600 mm
max. 10 bars
16 bars
max. 80° C
65° C
11 l/min 3 bars
locking screw
33891000
96338000
96391000
94194000
92730000
96059000
13913000
95049000
96510000
96556000