Publicité
Les langues disponibles
Les langues disponibles
GRILLE INSTALLATION
1. Refer to Figure 8. Compress grille mounting springs
and insert into slots in the housing.
2. Press grille firmly into place against ceiling.
MAINTENANCE
WARNING: Risk of fire or electrical shock; disconnect the power
•
before cleaning or performing any maintenance on the ventilator.
•
If the grille becomes soiled, use only a mild soap and water
solution for cleaning. Do not use solvents or abrasive cleaners.
INSTALLATION IN
EXISTING CONSTRUCTION
Installing a ventilator in an existing construction site requires
at least a small accessible area (attic or crawl space) above
the planned installation location.
Review "INSTALLATION IN A NEW CONSTRUCTION SITE"
and follow all instructions which apply to your installation.
Locate the ventilator next to a ceiling joist.
Plan the ductwork and wiring before proceeding with the
installation.
CAUTION: Check the area above the planned installation
to be certain that:
1. Ductwork can be installed or that the area is sufficient
for proper mounting.
2. Wiring can be run to the planned location.
3. No wiring or other obstruction will interfere with the installation.
INSTALLATION FROM ACCESSIBLE
AREA ABOVE (using headers)
1. From below the installation site, drill a small hole in ceiling at
the planned location.
2. Locate hole in attic or crawl space.
3. In attic or crawl space, mark ceiling for cutout by using the
housing as a template. Cutout dimensions: 10
3
The short side (10
⁄
") of the cutout must be right next to
16
the ceiling joist.
4. Refer to Figure 9. Mark cutout along marked line.
NOTE: If ceiling is plaster, cutout should be made from
below to avoid chipping plaster.
5. Install headers between joists using nails or screws leaving
3
10
⁄
" between them.
16
6. Install brackets upside down on housing's long dimension using
hex nuts.
7. Mount damper section to housing, install housing and connect
wiring and ductwork. Install power unit/blower assembly and grille.
3
1
⁄
" x 14
⁄
".
16
2
MOUNTING
BRACKET
HOOK HANGER
RODS FROM INSIDE
TO OUTSIDE
HANGER
ROD
SLOT
SPRING
MOUNTING
CLIP
MOUNTING
BRACKET
HEADER
HANGER ROD
POWER UNIT
FIGURE 7
MOUNTING
SPRING
FIGURE 8
HEADER
FIGURE 9
Publicité
