Indel Webasto Marine DR49 Instructions Pour L'installation Et L'utilisation page 23

The fuse blows.
A continuous buzzing noise
is heard.
Water drops are noted.
The noise of falling ice is
heard.
The ice has a stale taste.
The Ice Maker is too full of
water.
The Ice Maker is not making
enough ice.
The Ice Maker is stopped.
For more complicated defects requiring specialised assistance, please contact Indel
Webasto Marine S.r.l. Italia or your nearest Isotherm retailer.
54
The wrong fuse is being used.
Defective electronic control
unit.
The water valve is in
operation.
The water is filling the ice
production tray.
Ice is beginning to fall into the
collection tray.
The ice is old.
The Ice Maker is not perfectly
level.
The Ice Maker compartment
drawer is being opened too
often.
Check that the stop arm is in
operating position.
Check that the water valve is
working.
Make sure that the water
valve is not clogged.
User Manual
Check the fuse: 15 A (12 V)/7.5 A (24 V).
Replace the electronic control unit.
No operation.
No operation.
Once the tray is full, remove the produced
ice.
Make new ice.
Level the Ice Maker. If after levelling the
product, water continues to overflow, close
the water supply and move he stop arm to
the "off" position. Contact an authorised
service centre.
Adjust the temperature of the freezer
compartment to a colder setting.
Verify that the right amount of fresh air is
present for compressor cooling.
Reposition the stop arm in the right
position.
If the water valve is clogged or not
working, contact an authorised service
centre.