Beem Comfort de Luxe Mode D'emploi page 31

EN
Attaching the microfibre cloth
Put the floor brush onto the middle of
‹
the cloth.
Press and hold down one of the re-
‹
taining clips.
Put one end of the cloth under the
‹
retaining clip and release the retaining
clip.
Press and hold down the other retain-
‹
ing clip.
Put the other end of the cloth under
‹
the retaining clip and release the re-
taining clip.
To remove the cloth, press on the re-
‹
taining clips and pull out the cloth.
Attaching the accessory adapter
To use accessories such as the spot spray
nozzle (20) or the rectangular steam noz-
zle (16), you need the accessory adapter
(27). Fit this as follows:
Put the accessory adapter (27) onto
‹
the extension tube or onto the steam
gun (29).
While pressing the release but-
‹
ton (28), the accessory adapter can
be pulled off.
BEEM - Elements of Lifestyle
Comfort de Luxe
Connecting the spot spray nozzle with
attachments
Fit the accessory adapter (27).
‹
Push the spot spray nozzle (20) onto
‹
the installed accessory adapter (27)
and screw the spot spray nozzle tight
in clockwise direction.
Push the desired attachment (16, 21-
‹
25) lightly onto the spot spray nozzle.
Pull lightly to remove the attachment
‹
(16, 21-25) again.
The spot spray nozzle can be re-
‹
moved again by turning in an anti-
clockwise direction and pulling slightly.
Press the release button to pull off the
‹
accessory adapter again.
Attaching the rectangular steam nozzle
Fit the accessory adapter.
‹
Push the spot spray nozzle (20) onto
‹
the installed accessory adapter (27)
and screw the spot spray nozzle tight
in a clockwise direction.
Push the rectangular steam nozzle
‹
(16) onto the attached spot spray noz-
zle (20).
NOTE
► The rectangular steam nozzle can
be used both with the window at-
tachment (17) and with or without
the microfibre cloth.
31