GC EUROPE D Light pro Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Only if you experience little or no discomfort during and after use of the devise energy at the lowest energy setting, you can
increase the energy level, and so on for each subsequent session.
For detailed instructions on energy level setting, see "Inspection Before Use".
Always shave the area to be treated and make sure the skin is clean and dry before using the appliance.
Cover tattoos, lips and nipples before applying the appliance.
Cover dark brown or black spots, such as large freckles, birth marks, moles or warts before using the appliance.
Never use flammable liquids such as alcohol (including perfumes, sanitizers, or other applications containing alcohol), or
acetone to clean the skin before using the appliance.
Do not use the appliance on any body part where you might later want hair.
PATCH TEST
Before you begin the treatment, it is recommended that you perform a patch test to identify your skin's highest level of
tolerance to the pulsed light. For instructions on how to perform a patch test, see "Inspection before use" section.
DURING TREATMENT
Not treat the same area of skin more than once per session! Do not
repeat the spots!
HR spot = 2 flash
If blisters are formed on the skin, or if the skin burns, IMMEDIATELY STOP USING THE APPLIANCE.
Always make sure that the treatment surface points toward the skin, and is completely in contact with it.
Remove the surface treatment from the skin if it becomes excessively hot.
6
SR spot = 5 flash
INSTALLATION
1) Connect the Power Cord (5) See illustration below.
2) Mounting Lamps (HR and SR)
A
D
B
C
Pay attention when inserting the lamp. Behind the lamp there are 3 metallic pins (a b c) and a USB socket (d), during the
installation of the lamp, be careful to match these elements, equivalent to the handpiece. The installation and removal of the
lamp does not require any equipment and is done by hand. N.B. The USB socket is used only to connect the lamp to the
machine, any other use may be dangerous and damage the unit!
A
B
D
C
7

Publicité

Table des Matières
loading

Table des Matières