Care Of Your Product - babyDan Manhattan Guide De L'utilisateur

Manhattan high bed englargement module
ENGLISH
IMPORTANT.
RETAIN FOR FUTURE REFERENCE.
READ CAREFULLY.
Please take a few minutes to read the instructions thoroughly. Failure to do so may result in damage to the product or in
worst case injury to your child.
WARNING: All assembly fastenings should always be tightened properly and that care should be taken that no fittings are
loose.
WARNING: The high bed should not be used if any structural part is broken or missing.
WARNING: The high bed module is not suitable for children under six years due to the risk of injury from falls.
WARNING: Always use the fronts when the high bed module is mounted.
WARNING: Children can be strangled in items such as ropes, strings, cords, harnesses and belts attached to or hung on a high
bed.
WARNING: Children can become trapped between the bed and the wall. To avoid risk of serious injury the distance between
the top safety barrier and the wall shall not exceed 75 mm or shall be more than 230mm.
WARNING: Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas fires, etc. in the
near vicinity of the high bed.
WARNING: Do not use the high bed if any part is broken, torn or missing and use only spare parts approved by the
manufacturer.
WARNING: Do not leave anything in the high bed or place the high bed close to another product, which could provide a
foothold or present a danger of suffocation or strangulation, e.g. strings, blind/curtain cords, etc.
WARNING: Do not use more than one mattress in the high bed.
WARNING: The top of the mattress must never be beyond the mark on the inner side of the high bed.
WARNING: Be sure that all screws and fittings always are fastened and that there are no loose parts that the clothes or parts
of your child's body may get caught in (i.e. strings, chains, strings for soothers etc.). Do also regularly check that the high bed
is not damaged in any way.
WARNING: Use only replacement parts available from Baby Dan A/S.
INFORMATION:
Maximum thickness of the mattress is 10cm.
Recommended size of the mattress is 70x160cm.
The complete high bed complies with EN 747:2007.

CARE OF YOUR PRODUCT:

Clean the high bed using warm water and a mild detergent. Use a soft cloth to avoid scratches. Wipe dry with a firmly wrung
cloth.
Never use solvents, chemicals scouring powders or sharp tools in connection with cleaning the high bed.
2