Usb Setup - Onix DAC 25B Guide De L'utilisateur

Select Audio Source
1. Press the [SELECT] key on the front panel of the machine to select different input signals.
2. Display shows the input signal in circulation as shown below:
iPod
Note:
When you restart the machine, the input signal light will keep same as the last position of power off.
Earphone Volume Control
Turn the [VOLUME] knob on the front panel of the machine to adjust earphone volume. Turn the
[VOLUME] knob clockwise to increase earphone volume. Turn the [VOLUME] knob
counterclockwise to reduce earphone volume.
Upsampling
1. Press [SRC] key on front panel to illumine the upsampling light, it can be change the different
upsampling status.
2. Display shows the upsampling indication in circulation as shown below:
Upsampling off
Note:
When you restart the machine, the upsampling light will keep same as the last position of power off.

USB Setup

1. Connect the USB cable from the PC to the main unit.
2. Click the sound setup on the "control panel" of PC, Please select the playback option to the
corresponding device as default(XMOSXS1-L1Audio).
Remote control
1. Select the function switch to DAC.
2. Press the [ ] key or the [
3. When you use iPod input, [
song, the following song, play or stop.
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong
with this component, check the points below. Sometimes the trouble may lie in another component. Investigate
the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest ONIX authorized
service center or your dealer to carry out repair work.
Fault
No power Poor connection in socket or no utility.
Audio cable not connected.
No sound
Volume knob is at min.
Remote battery misplaced or depleted.
No remote control
USB COA-
96K
] key can select audio source.
] key, [ ] key and [
Possible causes
OPT-
1 92K
] key can control your iPod play the previous
Check power source and connect socket tightly.
Connect audio cable properly.
Adjust volume knob to proper position.
Reinstall battery or replace with new battery.
Treatment
5