Metal Cutting - Nupower EVOLUTION NPE55 Mode D'emploi

Dust extraction adaptor (pic.8) (NPE65)
This Jigsaw is equipped with a bayonet fitting dust extraction adaptor
(fig 8). Which can be fitted to a vacuum cleaner or suitable dust
extraction unit. To fit the dust extraction adaptor, fit the rubber "O" ring
onto the smaller diameter on the dust extraction adaptor and locate it
into the dust outlet at the rear of the machine. Push in firmly and twist
to engage the bayonet lugs.

Metal cutting

When cutting metals a suitable cooling/cutting oil must be used. Simply
squirt the lubricant onto the blade or work piece at regular intervals
during cutting to reduce blade wear.
Note: Do not immerse in water or allow coolant to enter the casing. A
fatal electric shock could occur.
Voltage
Motor Capacity
No load speed
Cutting Angles
Sound Pressure Level
Sound Power Level
Vibration Level
Weight
Max cutting capacity
Wood
Plastic
Steel
NPE55
230V ~ 50 Hz
450 W
500-3000 min -1
0° +/- 45°
LpA 84.6 dB(A)
LWA 97.6 dB(A)
4.22 m/s
2
1,8 kg
55 mm
10 mm
6 mm
17
Circle cutting
When starting a cut from the centre of the work piece, drill a 12mm
diameter hole to ensure that there is enough clearance for the blade.
Tip
When cutting materials with a decorative or polished finish cover either
the base of the Jigsaw or the surface of the material being cut with
masking or other suitable tape to prevent scratching.
NPE65
230V ~ 50 Hz
500 W
500-3000 min -1
0° +/- 45°
LpA 84.6 dB(A)
LWA 97.6 dB(A)
4.22 m/s
2
2,3 kg
65 mm
15 mm
6 mm
GB